Duracoat vs cerakote

Entdecken Sie die große Musikauswahl für jeden Geschmack im Thalia Onlineshop! F, fully cured when cool to touch C-Series – air cure can withstand high temps up to 0deg. Another thing to look at is the thickness. The you have all been waiting for are in. Such as on pistols on the ejection port when the slide moves over it, it will start to scratch up.

He says that you can apply cerakote thinner at mil. First, we want to explain a bit about how the Salt Spray Test works. Ceracoat vs duracoat vs re-blånering ( drilling) Sign in to follow this. Both will need a good degreaser and the ability to strip the old finish from the gun. It does not cure as fast as the MFG states, BUT it does hold up when prepped and applied correctly!

DuraCoat finishes can run from 0. I know cerakote is harder to work with but I have a compressor, HVLP mini touch up. Duracoat gets a bad rap due to impatience mostly. CeraKote er en keramisk finish med eksepsjonell slitestyrke, slagfasthet, fleksibilitet, rustbeskyttelse og solventsikkerhet som tåler ekstreme temperaturer. When it comes to any coating, prep is going to be the key to success, so it stands to reason that if you truly want a long-lasting, durable finish, the shop that does the work is going to make more difference than the bran especially in this case. Ours was done by ColoradoKote , a high-end custom firearms shop in Lovelan Colorado.

Neither is necessarily better or worse than the other an properly done, neither should have any issues with wear in normal use. Cerakote is primarily a heat-based curing product. The duracoated stocks I make I stick into an oven at centigrade for at least hrs. I think this does increase hardness and durability. Which is the best one to go with?

Stock comes Camo from McMillian. Thanks for any advice. I’m being advised DPC. Well, these are actually very simple questions once you understand the two products a little better. If one scratches against rocks the paint does come off, all in all only a few scratches after years.

Pussa først rifla ned med sandpapir (400) også la på duracoat med Airbrush med filter på kompressoren. Finishen ble fin den, men jeg fikk ikke avfetta før jeg gjorde det så pussa bare ned med papir og børsta av overflødig smuss. No, I have not subjected my guns to 4hours of salt spray. I simply use them as I would any firearm.

I have known the Lauer family personally for many years now. All have the same issue. And then to further complicate things, you have the very popular camo dip finishes. I use GunKote on the work I do.

Was darned disappointed in CeraKote done by Amelon. Is already wearing at the edges. C på min remington 70 var innom mekonomen tidligere idag for å handle noe deler til bilen og der såg eg dei blander lakk på sprayboks å dette fikk meg til å tenke!